1,308
edits
Cues: Difference between revisions
→Making Cues
| Line 17: | Line 17: | ||
* SMPTE countdown is measured in seconds and will start at the number 8. Academy countdown is measured in feet and will start at the number 12. It's important to know the difference, because you will thread to a different number depending on what type of countdown you're using. Both types should be 12 feet in length if no frames have been removed. | * SMPTE countdown is measured in seconds and will start at the number 8. Academy countdown is measured in feet and will start at the number 12. It's important to know the difference, because you will thread to a different number depending on what type of countdown you're using. Both types should be 12 feet in length if no frames have been removed. | ||
[[File:Bad grease cues.JPG|right|thumb|300px|Incorrectly made grease cues (too large, marked on emulsion side, and lab cues were perfectly fine at only 18 frames from the end!)]] | [[File:Bad grease cues.JPG|right|thumb|300px|Incorrectly made grease cues (too large, marked on emulsion side, and lab cues were perfectly fine at only 18 frames from the end!)]] | ||
| Line 32: | Line 32: | ||
Changeover Cue ➔ 24 frames (last image) = total 200 frames''' | Changeover Cue ➔ 24 frames (last image) = total 200 frames''' | ||
*WEAR GLOVES and ALWAYS MARK THE BASE SIDE. Mark your changeover and motor cues over 4 frames. Because you have the film running tails to heads on the rewind | ==How to make grease cues== | ||
* | *WEAR GLOVES and ALWAYS MARK THE BASE SIDE. Mark your changeover and motor cues over 4 frames. Because you have the film running tails to heads on the rewind and you’ll be marking the base side you will have to flip the film over (just a loose twist), so the film is base up. Mark the cues on the side opposite the soundtrack on the top of the frame. Just a short dash from the corner in towards the center a few centimeters will do. As small as you can while still being able to see it. | ||
*You may notice that there is That extra footage is to account for the time it takes for the motor to ramp up. Some projector motors are slower in which case you might thread to a lower number to make up for that. If a film has been previously cued but say the changeover cue has been spliced off, you may want to count back less than 18 frames to avoid clipping anymore of the film than you have to. I would say 12 at the minimum to avoid having a pretty bad changeover. | |||
*Making cues on a fade out: If there’s no splice to help you, look for when the audio ends and use your best judgement. There should be a lab splice or a splice from the negative that you can count back 172 frames from. If you’re comfortable you can do a changeover on a fadeout with just the motor cue, use your ears for the change over cue! | *Making cues on a fade out: If there’s no splice to help you, look for when the audio ends and use your best judgement. There should be a lab splice or a splice from the negative that you can count back 172 frames from. If you’re comfortable you can do a changeover on a fadeout with just the motor cue, use your ears for the change over cue! | ||